Rosewood ST1000LM035 Stays BSY after getting ready

[Freekingeeks]

Hello,

This rosewood drive gets ready but goes to BSY as soon as I try to access any sector.

below is terminal output.

(P) SATA Reset

RAW OFF
PASS
Drive AMPS Configuration has been modified from compiled defaults.
Drive must be re-initialized to controller firmware defaults by re-downloading controller firmware
DO NOT SHIP WITHOUT FIRST RE-DOWNLOADING CONTROLLER FIRMWARE OR RESETTING TO DEFAULTS!

(DOS Table) Worst Count: 00000FFA At SU: 0000531D NT: 00000000 OT: 00000020
MSP213
(MC POR Duration): 0000000045
PrgF
PrgF
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps
DSC
Common path start quit now ProcessRC: 00000000,00000000SkipLen: 00000000ReadContinuous: 0E06D933,00000322UnrecovSectorCount:00D7,0321,0042NumUDEs: 000000D7,00000003,00000321Passed: 00000080,00000140,000002D1Out:
PE  43110081
PrgF
LED:0x000000EE FAddr:0x004E6CE0

LED:0x000000EE FAddr:0x004E6CE0

LED:0x000000EE FAddr:0x004E6CE0

I have got all the important modules backedup. Also when I try to write updated 93 in indirect ATA mode it gets bsy and fails.

Kindly advise.

 

[pclab]

Can you execute any terminal commands?
Do you get a reply?

All your SYS files are OK?

 

[Freekingeeks]

Hello,

Yes I can execute the terminal commands and have already downloaded all of the essential SYS files.

 

[pclab]

No errors on translator Sys File?

 

[Freekingeeks]

No errors in reading